The Mielta M1 is a small, easy to use and economical car tracker. Its small size (only 7×5 cm), built-in antennas (GPS, GSM, Bluetooth) and a minimum number of connected wires greatly facilitate the installation of the tracker. Interfaces RS-485 and Wire-1 allow you to connect up to 16 digital sensors. Bluetooth 3.0 expands the capabilities of the device when configuring and connecting additional sensors.
Thanks to the unique power supply, the tracker can work efficiently both from the vehicle’s on-board network and from the USB connector. The Mielta M1 also has two universal ports, a 10,000-point black box, one SIM card and an integrated accelerometer. Possibility of remote configuration and a large list of supported peripherals.
| Nutrition | 5 – 36 V |
|---|---|
| Average power consumption | 1 watt |
| Battery | Optional |
| Universal ports | 2 pcs. |
| Analog input | voltage from 0 to 36 V, input impedance 30 kOhm, resolution 10 bits |
| Discrete input | 3.3 V, resistance 20 kOhm, frequency up to 10 kHz, counter up to 1,000,00 |
| Discrete output | open collector, current up to 200 mA, self-induction protection |
| 1-wire | built-in, up to 8 devices on the bus |
| RS-485 | Built-in, up to 8 devices on the bus |
| USB 2.0 | Configuration, firmware, data transfer, power |
| Satellite antenna | Built-in 25×25 mm |
| GSM antenna | Built-in |
| Bluetooth 3.0 | Built-in, configuration, firmware, data transfer |
| Built-in memory | 4 Mb, 10,000 points |
| SIM card | 1 pc, micro-SIM |
| Data transfer protocol | Wialon IPS 1.1, IPS 2.0, binary |
| Degree of protection | IP44 |
| Operating temperature | from -40 to +80 ° С |
| dimensions | 49 x 64 x 17 mm |
| Weight | 60 g |
Reviews
There are no reviews yet.